|
|
 | |
|
| Products>Pumps>Centrifugal Pumps>Multistage Centrifugal Pump TYPE MS |
|
| |
| |
 |
| Multistage Centrifugal Pump type MS, DMS, MSTD, MSS |
|
|
|
Technical data:
CapacityUp to 100 l/sec
HeadUp to 300 m
TemperatureUp to 160 °C
Design: The MS is our new process duty, horizontal multistage centrifugal pump. Designed for moderate to high pressures heads, the MS is available in five basic sizes.
The MS pumps are offered with suction and discharge flanges according DIN standard, depending on the pressures and number of stages involved.
The suction and pressure bodies can be turned for 90°C in both directions which enables the pumps to be mounted and adopted to the requirements of the installation.
Axial thrust is relieved by means of a drum mounted on the shaft inside the discharge hull, the rest of the thrust bears one of the roller bearings.
The impellers are centrifugal of closed type identically fixed to a shaft supported on two roller bearings.
The shaft sealing in standard execution is executed by means of soft cord packing and the shaft is protected by hardened sleeves. As option mechanical seals are available.
|  | |
|  | |
| | |
|
Multistage Centrifugal Pump TYPE MS |
|
| | |
Application:
Hydraulic performance extends to 100 l/s capacity and 300 meters head, which compare them to all favorite pump types and makes them to all favorite pump types and makes them ideally suited for the most demanding industrial and process services.
The MS pumps in standard executions with soft seal packing can be used for handling water up to temperature of 900C, then as water supply pumps, irrigation and drainage pumps in agriculture, water circulation pumps, in mining etc.
In the versions with mechanical seal they can, besides the uses listed above, be applied in oil industry for the transport of thin oils, petroleum and petroleum products up to temperature of 90°C.
In special version these pumps can be used in chemical and process industry.
However, in each particular case of pump selection, especially, if they are intended for special purposes, it is necessary to consult the manufacturer.
Municipal water supply
Industrial plants
Agriculture irrigation
Chemical and light hydrocarbon transfer
Coating and surface treatment
High rice building sprinklers
Paper mill shower water
Pressure boosting systems
Sanitary wash down services
Rotating equipment lube and seal oil supply
Oil industry
Chemical industry
Thermo energetic plants
Mining, civil engineering
Performance: The MS is our new process duty, horizontal multistage centrifugal pump. Designed for moderate to high pressures heads, the MS is available in five basic sizes.
The MS pumps are offered with suction and discharge flanges according DIN standard, depending on the pressures and number of stages involved.
The MS pumps can run continuously in the operating range providing this is within the motor rating considering NPSH values required by the pump.
All of the pumps can operate at different speeds. The hydrodynamic values ought to be calculated in accordance with the law of similitude. For higher speeds it is necessary to check the pump limitation.
The performance curves are based on a liquid density of 1000 kg/m3. For working fluid density below or above 1000 kg/m3 it is necessary to multiply the power.
For sizing of the drivers you have to add a minimum of 10 to 15% of the pump absorbed power, depending on operating conditions, eventually a higher factor could be necessary.
Downloads:
|
|
|
The pumps can be ordered as individual pump or as complete pumping unit which consists of pump, driver, flexible coupling and mounted base frame.
As standard the pump's drivers are electric motors, but it could be any other device as: internal combustion engine, turbine, etc.
|
| « Back to Centrifugal Pumps |
|
| |
|
|
|
|
| |
|
